Raspberry Mead – Micro Batch Recipe (2024)

Every year I’m excited about fermenting up something tasty with raspberries. Raspberry wine, raspberry mead or even a light summery raspberry beer.

Just one problem…raspberries are wicked expensive. Do you know how many raspberries it takes to make even a gallon of raspberry wine?

For beer or mead, it takes about a quart in a one-gallon batch, or over a gallon of fresh fruit in a 5-gallon batch to really get the flavor to come through. Around these parts, even pick your own berries are pricey, and those from my own raspberry patch are gobbled before they hit the bowl.

So why not a micro-batch?

Raspberry Mead – Micro Batch Recipe (1)

There are a lot of greatreasons to make a micro-batch mead. For raspberry mead, a micro-batch is a great way to keep your costs down without sacrificing flavor. With just barely a handful of raspberries, you can make a quart batch of raspberry mead that is brimming with raspberry goodness.

It’s also a good way to see if a sweet and VERY fruity mead is your cup of tea.

All you need to start is a bit of honey, raspberries, a quart mason jar, and a mason jar fermentation kit. There are a number of brands to choose from. Try this one. Or this one.

I use a kit byFermentoolsthat looks a lot like a home brew setup, and if you choose to do bigger batches later you’ll need the rubber stopper and water lock that are included in the kit.

I’m hoping at some point to try out thesesilicone fermentation lidsfrom Mason Tops because they look super easy to clean.

Raspberry Mead – Micro Batch Recipe (2)

One quart batch of raspberry mead with a Fermentools fermentation kit (water lock).

Start by adding a bit of honey to the bottom of a quart mason jar. The basic instructions for a one-quart batch of mead have you add between 2/3 of a cup of honey and 1 cup of honey to get the right ratio of honey to water in your jar. With the added fruit sweetness, stick to 2/3 of a cup.

I’ve tried a full cup for this recipe, and it was cloyingly sweet and just a hair shy of cough syrup. Adding 2/3 of a cup is more than enough for a sweet dessert mead, and if you’re looking for something drier, go with 1/2 cup.

For raspberries, I had a half-pint (one cup) easily at hand. They were super fresh, about 10 minutes old from my patch. One cup is all I could keep from eating out of hand before I made it back to the kitchen, but it was plenty for this micro-batch.

Raspberry Mead – Micro Batch Recipe (3)

Quart mason jar with 2/3 cup honey and 1 cup raspberries for a micro-batch raspberry mead.

With honey and raspberries in the jar, getting your mead going is pretty effortless. Bring about 3 cups of water to a boil on the stove, then cool slightly for about 30 seconds before pouring it directly into the jar over the raspberries and honey.

Stir to dissolve the honey and incorporate the raspberries.

Once it’s cooled to room temperature, or at least cooled to 90 to 100 degrees so it won’t kill the yeast, add in a brewing yeast. For meads, I use packages of champagne yeast. One pack is enough to pitch a 5-gallon batch, so using the whole packet is overkill for a micro-batch.

I usually use about 1/4 of a yeast packet because it’s hard to actually extract less than that from a tiny packet. Dissolve it in room temperature chlorine-free water and pour it into your mason jar.

Related: How to Make One Quart of Mead (Micro Batch Method)

Raspberry Mead – Micro Batch Recipe (4)

Once it’s all said and done you should have 2/3 cup honey, 1 cup raspberries, a bit under 3 cups of water and about 1/4 of a packet ofchampagne yeast in your mason jar. Be sure to leave about an inch of headspace to allow for expansion and bubbling during fermentation.

Add on your mason jar fermentation kit and allow it to ferment at room temperature, out of direct sunlight for about 6 weeks.

The initial fermentation phase can be a bit intense, so after the first week if any fruit has made it into your water lock, pop it off and clean it out. Be sure to get it back on tight for the rest of your fermentation time.

When fermentation is complete, carefully pour off the mead into another jar, leaving the sediment behind.

I bottle mine, and allow it to age inGrolsch bottles for at least 2 weeks, preferably a bit longer.

Then, enjoy!

If you’re looking for more details on how to make a micro-batch mead, you can read an introduction to the micro-batch method here.

Raspberry Mead – Micro Batch Recipe (5)

Related

Raspberry Mead – Micro Batch Recipe (2024)

FAQs

How many raspberries for 1 gallon mead? ›

You'll need 3 pounds of honey and roughly 6 ounces of raspberries per gallon.

How long does a small batch of mead take to ferment? ›

Fermentation should last between 10 to 20 days. Rack into a conditioning vessel and bulk age for 3 to 6 months. Bottle, then enjoy now and again to see how it's progressing.

How much honey is needed for a batch of mead? ›

How Much Honey Should I Use? In this recipe, you can choose exactly how sweet you'd like your wine to be. We'll go over it in further detail later, but we recommend using between two and three pounds of honey per gallon of mead — 2 pounds if you want it on the dryer side, and 3 pounds if you'd like it to be sweeter.

How much fruit do I need for 5 gallons of mead? ›

There really isn't a rule of thumb saying, “Add 3 lbs of every type of fruit to get a light flavor and 6 lbs of any fruit to get heavier flavor”. Different fruit gives different amounts of flavor. That is why this is so helpful. All of these additions would take place in Secondary and all are for 5 gallons of mead.

Can you put too much honey in mead? ›

If you put in a bunch of honey and you get enough yeast (the right kind of yeast where it ferments all the way out) then you'll have a really dry, high alcohol champagne-like mead. You can use less honey to make a lower alcohol mead. Using less honey might make it a little bit more dry, though not necessarily.

How long do you leave berries in mead? ›

Pour the fruit puree into the fermentation jar. Rack the mead from the carboy to the fermentation jar, taking care to leave as much lees as possible at the bottom of the carboy. Place the lid on the jar and refrigerate for 1 to 2 weeks.

Can I bottle mead in mason jars? ›

Yes you can bottle in mason jars. No you should not heat them as it will damage the delicate mead. It is probably not the best container as I don't think the lid provides the best seal without a vacuum in the container, however it will still work for shorter term storage. My personal preference is to use beer bottles.

How long should mead age before drinking? ›

Traditional meads usually require six months to 2 years for the flavors to mellow and smooth and any off flavors to diminish. Melomels or fruit meads can take six months to 5 years for the flavors to fully integrate and the tannins and acids to mellow. Metheglin or spiced meads are quicker, six months to a year.

What is the shortest time to make mead? ›

If you're using less honey to make more of a beer-like mead, those can be fully fermented and drinkable in under a month. Other types can take a few months. It just depends on the amount of honey. Amount of honey primarily is what it depends on, and some yeasts ferment honey faster than others.

Why does no one drink mead anymore? ›

Why did it fall out of favor? There were some new tax laws, as well as an increased availability of West Indian sugar in the 17th century that made honey harder and less necessary to obtain. But it was also the rise of other alcohols—namely beer and wine—that really did it in.

What is the best honey for berry mead? ›

Here are some of the best kinds of honey to use in producing mead.
  • Local Honey. Almost any really tasty local honey will end up producing an excellent mead. ...
  • Orange Blossom Honey. ...
  • Dark Honey. ...
  • Raw Honey. ...
  • Clover Honey.
Mar 20, 2022

Is raw honey OK for mead? ›

The best honey for mead is raw and local. If you have our Mead Making Kit & need honey to get started, try some of our favorite regional honey varieties: Clover & Midwest. The perfect bulk honey for mead, each bottle contains 40 oz (2.5 lb) - exactly what you need to ferment 1 gallon of mead.

How often should I stir my mead? ›

Stirring twice a day is generally sufficient (if you have a fast fermentation, you might want to stir three or four times a day). Stirring does a couple of things: It blows off carbon dioxide, which lowers potential yeast stress, and it adds oxygen to your mead when the yeast can use it best.

Can you use canned fruit for mead? ›

You can use fresh, frozen or canned fruit depending on availability. Whichever type you use, it is important to follow the guidelines below: If you're using fresh fruit, peel or clean, cut up, and freeze it. Freezing breaks the cell walls, and will help release more of the fruit flavor later.

Should you puree fruit for mead? ›

While fruit puree works well for adding an accent flavor to a beer, they are very difficult to separate from a mead. The problem is that you need a lot of fruit to make this style of mead, and using that much puree makes it hard to separate the puree sediment from mead, resulting in high losses.

How much fruit per gallon of mead? ›

A good starting point with most fruits is about 3 pounds of fruit per gallon of mead, though I have been known to use 5 or even 6 pounds of fruit. Fruit blends can produce some great-tasting meads.

How much is 4 cups of raspberries? ›

They estimate that an actual pound of raspberries is about four cups, or 135 average size raspberries. This many berries can be found in a one-quart container as well as a one-pound container. A one-pint container holds about half the volume of a one-quart container.

How much honey is needed for 1 gallon of mead? ›

The ratio ranges from 1 lb. honey per gallon of water for a very light "soft-drink" to 5 lbs. per gallon for a sweet dessert wine. The less honey, the lighter the mead, and the quicker it can be made.

How many gallons of water do raspberries need? ›

A new planting in sandy loam soil requires 18 gallons per day per 100 feet of row. A mature planting in the same soil type requires 27 gallons per day per 100 feet of row. Increase the water rate for sandier soil, and decrease it for heavier soil.

Top Articles
Latest Posts
Article information

Author: Golda Nolan II

Last Updated:

Views: 6300

Rating: 4.8 / 5 (58 voted)

Reviews: 81% of readers found this page helpful

Author information

Name: Golda Nolan II

Birthday: 1998-05-14

Address: Suite 369 9754 Roberts Pines, West Benitaburgh, NM 69180-7958

Phone: +522993866487

Job: Sales Executive

Hobby: Worldbuilding, Shopping, Quilting, Cooking, Homebrewing, Leather crafting, Pet

Introduction: My name is Golda Nolan II, I am a thoughtful, clever, cute, jolly, brave, powerful, splendid person who loves writing and wants to share my knowledge and understanding with you.